Bongs Tips for The Average Joe

Smoking with a Glass Bong

In order to make a glass bong you must be brothers with glass that is you must be able to manipulate glass easily. This is because the glass bong if well made it can be able to sustain you for a long time unlike a plastic bong.

If you are brothers with glass then you can be able to make a bong unlike most of the people who do prefer buying glass bongs. That can be able to operate the same way as a shop or a made bong this can be achieved by collecting a few materials.

The first material that you will have to have is a glass bottle the glass bottle will have to have the unique features of a bong. That is the bong should have a long neck and a wide base this to have the area to be passing the smoke.

The next thing is to get a drill bit after finding the bottle with the correct features in order to drill the bottle this is because the hole that will be made on the bottle will need to be very precise in order for the bong to work.
You should get a down stem with measurements that will be able to rhyme with the hole drilled through the bottle hence the need to be brothers with glass the down stem needs to fit perfectly in order for the smoke not to be lost through the spacing.

You will require a rubber grommet when you don’t end up drilling the hole with precision in order to be sealing the area that is not going to be airtight this is to give you the precise smoke hits that you may want to be taking.
When you have collected the items you can now start preparing the bottle for the drilling this is by washing the drill with warm water the warm water helps in the drilling since the surface area is made smooth by the drill.

When you are going to be drilling drill in the sink in order to get rid of the debris that may cause harm if they are left all over the floor by doing this you will be ensuring that the environment that you are working on is clean and safe to use.

Mark the bottle when it is in the sink the mark is to indicate where you are going to be drilling and start drilling by marking you will ensure precision and also ensure that you drill in a flat surface in order for the drilling to be successful.

In order to keep the drilled part from breaking after drilling immediately run cool water on the drilled part, after you are done drilling put the grommet and the bowl using the rubber and your glass water bong is ready to use hence you being brothers with glass.

5 Uses For Options

6 Facts About Products Everyone Thinks Are True